Garage door won't close: sensor repair in White Plains

If the door won't close from the remote and the opener light blinks, the sensors are the first place to look.

Call (914) 758-1299

In short

Blinking sensor light, door reversing, or a door that only closes while you hold the wall button: all three point to the photo-eye sensors. Clean and realign them first. If that doesn't work, call, and a technician in White Plains repairs the sensors and re-tests the opener's safety system.

Wi-Fi garage door opener mounted on the ceiling

Doors that won't close in White Plains

In Gedney Farms, Rosedale and the Highlands, many garages are built into the house or set at the bottom of a sloped driveway. Water, grit and leaves wash down to the door and collect exactly where the sensors are. A door that reverses after rain, or after the landscapers have been through with blowers, is usually reacting to debris in the beam or a wet lens. In Battle Hill and Fisher Hill, tighter single-car garages mean the sensors get knocked by tires and bins.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

What you can safely try yourself

Clear the doorway, clean both sensor lenses, and check that the two sensors point at each other at the same height. A steady light on each side means they can see each other. If one keeps blinking after that, or the wires look damaged, leave it for the technician.

Never disconnect the sensors or move them up out of the doorway to get the door working. They are what stops the door from closing on a child, a pet or a car.

Fixing it properly

Most of these visits are short. Sensors are realigned or replaced as a matched pair, damaged wire is rerun and secured, and the opener's travel and force are set for your door. If the opener is old enough that it has no working safety reverse at all, the technician will say so and explain the options, and nothing is replaced without your say-so.

Around White Plains

  • The Highlands: Hillside streets near the high school with built-in garages.
  • Ridgeway and Prospect Park: Established streets between downtown and the Scarsdale line.

See the full White Plains service area.

Leave the door where it is and call.

Springs and cables hold a lot of tension. Don't lift the door by hand or keep pressing the opener; call and we'll book a technician.

Call (914) 758-1299
Call (914) 758-1299